Vehicle runs lean causes misfire

There is lots of thumping noise and vehicle idles rough.

On such cases the diagnostic codes received are P1151 and P1131.

Also the misfire Error codes will be  received.

P1151 and P1131 codes are for the O2 sensors are for lean concerns which indicate there is to much oxygen left over in the exhaust or not enough left over fuel. Normally this is the result of a vacuum leak after the MAF sensor. So the lean concern can be causing your misfire codes 0300 and 0316.



Try these test procedures:---
Run the engine cold. Spray short busts of starting fluid around all the vacuum and PCV hoses and the intake gaskets. When a leak is hit, the rpms will increase.


Also on some cases you will hear noise from intake
If you have a noise in the intake, there is a good chance it is cracked as well as leaking.

So inspect the intake manifold too.

Also on such cases the fuel pressure is important.So inspect the fuse pressure.If its very low or very high,then fuel system, parts needs to be inspected and replaced if checked weak.

The fuel system consists of fuel pressure regular,fuel pump,fuel filter and fuel itself.

If the fuel in the vehicle gets dirty,or thick,then it can cause such problems.Getting the dirty fuel replaced with good fuel helps.

Thanks,.

Users Who Viewed This Problem Also Viewed:

Fuel Running Lean

http://technoanswers.blogspot.com/2012/10/fuel-running-lean.html

2006 Ford F150: Rough Idle and Vibration?

http://whatisbyme.blogspot.in/2012/05/2006-ford-f150-rough-idle-and-vibration.html

Ford F-Series Rough Idle/Vibration?

http://whatisbyme.blogspot.in/2012/05/ford-f-series-rough-idlevibration.html

1995 Toyota Corolla: Stalls, Sputters and Pops Through Intake Manifold?

http://whatisbyme.blogspot.in/2012/05/1995-toyota-corolla-stalls-sputters-and.html

1994 Lexus ES300: Engine Idles Rough and Dies?

http://whatisbyme.blogspot.in/2012/05/1994-lexus-es300-engine-idles-rough-and.html